Sizing Your Solar Energy Panels – Part 3

- Image via Wikipedia
This is the third and final part of the “Sizing Your Solar Energy Panels” series. Have you done some calculations for your future solar power system yet? If you have been doing those mini exercises, you’ll most likely find a suitable solar panel for your home by now.
The next step requires us to find an appropriate-sized battery bank, inverter and charge controller. Let’s look at each of these:
1. The Inverter
The inverter you choose has to be sized according to the demands of the alternating current (AC) side of the circuit. Therefore you will choose a specification according to the loads in your house (with a little buffer in case you increase your loads over time). Pretty straightforward.
2. The Charge Controller
You’ll at least need a basic charge controller to begin with. Until you get fussy about how advanced you want this component to be, more affordable models will do just fine. You’ll need to get a specification that fits the output current (Amps) of your solar panel arrays. If you intend to scale up your solar power generator, you’ll do better with a larger charge controller with room to accommodate more solar panels than with two smaller-sized ones.
3. The Battery Bank
The size of your battery bank depends on how you want to use your solar panels. You can size your battery banks such that it can get you through thick clouds that pass by, or you can size them so you can get through three solid days of solar eclipse and a power outage at the same time. It really depends on you. But take note that over-sizing isn’t always realistic. You have to take into consideration the space they occupy and the how much they’ll cost you.
If your home is grid-tied, provided there aren’t frequent power outages, the size of your battery bank isn’t critical. Just size it to take care of cloudy days will do. You can still maintain your lifestyle by drawing power from the grid.
When you design your battery bank, you’ll have less power loss (through wires) if the voltage is higher. If you are able to design a 48-volt system, you can conserve more power than when you use a 24-volt or 12-volt system.
Continue Reading At:
- DIY Solar Panels — Charge Controller Basics Image via Wikipedia If you’ve ever built DIY solar panels of a considerable size, you’ll probably come across this important component — the charge controller. The role of a charge controller is to regulate the charging voltage on the batteries. When sunlight gets brighter, solar...
- Sizing Your Solar Energy Panels – Part 1 Image by Getty Images via Daylife In order to size your solar energy panels, you have to decide if you want a direct grid-tie system without batteries or not. If you do not want to use batteries, the size of your solar power generator will...
- Sizing Your Solar Energy Panels – Part 2 Image via Wikipedia After you know where most of your household energy goes to, you are now ready to plan for your system size. For grid-tied system (without batteries and charge controllers), you only need to make sure the inverter you use is large enough...
- Solor Panel Inverters – Multifunction Solar Panel Inverters Image by Getty Images via Daylife Are you ready for what Multifunction Solar Panel Inverters can do for you? Let’s jump right in… Multifunction solar panel inverters combine the best from Stand-Alone Solar Panel Inverters and Synchronous Solar Panel Inverters. They are of course more...
- Survey Your Household Energy Usage Before Installing Solar Panels An important step to take before you install solar panels is to do a thorough survey on how you use energy at home....
- Creating An Energy Efficient House – A Primer On Why You Should Do It and How There are 2 important reasons why you must create an energy efficient house. First, you can reduce your energy bills by as much as 30%. Second, you can reduce your carbon footprint. But how should we do it?...
- How To Calculate The Wire Size Required For Making Solar Panels Electricity is like water while wires are like pipes. With smaller pipes, less water can pass through. Similarly with thin wires, less current can flow through....
RSS feed for comments on this post. TrackBack URI


